Armor clarification

Dark Jedi

Active Hunter
on the ESB armor does the colar piece attach to the the back plate or is there a gap. I assumed they wer two seperate pieces and did not touch.:confused
 
my understanding is that the collar overlaps the backplate on top...and then they are attached using the collar studs...:)
 
Terrek Rysin said:
By the by, since the studs connect the two pieces at the top, where do I attach the bottom of the back armor?

It's not attached, the jet pack and the collar studs keep it on place (y)
 
i attached my backplate with snaps to the flak vest at the shoulders and down low. my neck plate is the one that is free floating now attached with the collar studs.
 
Im a little concerned because I am using the templets found else where on this site, and if I force the collar to touch the back plater the armor chokes me. Then the problem becomes which piece (collar or plate) do I make inaccurate so it fits, of am I thingking of this wrong?
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top