WOF Gauntlet Help

Hi guys. Well, over the weekend I built a right gauntlet out of 100 pound paper using the WOF template. It turned out fine, except I need to tighten it up in the front so it fits snug, and in the rear I need to let it out as my upper forearm is a bit big. Can anyone advise me as to how I can get it to fit properly? My goal is to do a final piece using 1mm Sintra, take silicone casts off of it and run resin pieces. The design will feature the standard clamshell design with a hinge. I'd like to get it to where it will fit my arm without having to add all kinds of padding. Can anyone help me out? Thanks!
 
I would try wrapping a piece of paper around your forearm till its the snuggness you want. then mark the seam to give you the outline for the template.
 
does it fit loose over just your arm? have you allowed for a sleeve to fit in there too?
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top