My Boba armor Scratch build

Darth Voorhees

Well-Known Hunter
Preferred Vendor
Well i decided to try out the WOF templates and make my own chest/ab shoulder armor. I had a nice size sheet of ABS laying around so i just used that.

heres where im at now..what do you guys think?

left chest plate before hittin it with the heatgun to curve it:
Leftchestplate.gif


And here is both sides of the chest after curving with the heatgun and the medallion:
fullchest.gif
 

Attachments

  • Leftchestplate.gif
    Leftchestplate.gif
    6.4 KB · Views: 163
  • fullchest.gif
    fullchest.gif
    6.4 KB · Views: 152
thanks guys!

heres the full chest/ab armor. Just need to add the dent in the ab section.
chest-ab.gif


So i think this is workin out prettygood. Its just ABS cut out with a dremel,and sanded edges.

thats all for tonight! im off to bed!
 

Attachments

  • chest-ab.gif
    chest-ab.gif
    6.4 KB · Views: 154
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top