My bucket

gunnerk19

Active Hunter
Got a start on my Fang helmet, here are a few pics...

The ears temporarily in place...
fangbobahelm001.gif

fangbobahelm002.gif


Base coat is Testor's "aluminum plate" metallizer...
fangbobahelm005.gif


Scratched the borden connector out of styrene, the molded one was kinda deformed...
fangbobahelm003.gif


Scratched hollow RF stalk...
fangbobahelm006.gif
fangbobahelm007.gif


And the homemade RF lens...
fangbobahelm009.gif
fangbobahelm004.gif


My intent is to paint it as close to the MoM ROTJ as I can, should be fun :D
 

Attachments

  • fangbobahelm001.gif
    fangbobahelm001.gif
    6.4 KB · Views: 106
  • fangbobahelm002.gif
    fangbobahelm002.gif
    6.4 KB · Views: 114
  • fangbobahelm005.gif
    fangbobahelm005.gif
    6.4 KB · Views: 116
  • fangbobahelm003.gif
    fangbobahelm003.gif
    6.4 KB · Views: 117
  • fangbobahelm006.gif
    fangbobahelm006.gif
    6.4 KB · Views: 114
  • fangbobahelm007.gif
    fangbobahelm007.gif
    6.4 KB · Views: 119
  • fangbobahelm009.gif
    fangbobahelm009.gif
    6.4 KB · Views: 117
  • fangbobahelm004.gif
    fangbobahelm004.gif
    6.4 KB · Views: 117
Looking good so far! I'm curious how you got the frosted look on your RF lens. Did you lightly sand the back side of clear acrylic sheet?
 
Firespray, I used pieces cut from a CD case and fine sanded them. The green lines are 1/16" clear acrylic rod sanded and painted with transparent green...

Thanks guys, hopefully my patience holds out and it ends up comparable to some of the excellent helmets I've seen here. Besides, gotta have a little love for ROTJ... :lol:
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top