Collar back armor. I need help

hey brother, check out what i did for mine in my harness thread...

http://www.thedentedhelmet.com/showthread.php?t=29943

go down to the second set of pics, and you can see how i have the collar and backplates connected...i bought some collar studs from Serenity, aluminum, and they work perfect! the collar studs in the pics are made by me, prior to that purchase...let me know if you need any more help...
 
Short answer: Yes. The collar plate slightly overlaps the back plate.
I'll see if I can find a good pic from the archives.

Edit--found one. This shows the overlap.

MoM_2002-06-16_080.jpg
 
Last edited by a moderator:
Hey SJ, looking at the picture you posted I stumbled about those two green screws that go through the cape.

I have seen other shots to know there´s a green metal plate below it.

Could you tell me for what reason they did this?

Can´t imagine what this would be good for ... ?

Thanks for any hint. :)

Manuel
 
I didn't realize this as well. Looking at Fettdad's pics and Superjedi's picture, it looks to be a choking hazard. Is this the case?
 
A choking hazard? Well, I dunno about you, but the armor pieces are a little too big to fit in my mouth, so I'm not really worried.

:lol:

Are you talking about how the parts fit around your neck?
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top