Boushh Boushh Project

So while I am waiting for more fett paints to arrived, I figured I would start to fiberglass this thing...

1) Outside is coated in resin...

DSC03834.jpg


2) Started to glass the inside...

DSC03833.jpg


3) Me trying not to die from the fumes or my Plo Koon imitation...

DSC03839.jpg
 
Last edited by a moderator:
:lol:..., lovin the progress, makes me wanna start mine all over again (y)

Quick question though, Do you find that the resin makes the card/paper sag atall, or have you just painted a thin layer to get the regidity?

cheers
Steve
 
:lol:..., lovin the progress, makes me wanna start mine all over again (y)

Quick question though, Do you find that the resin makes the card/paper sag atall, or have you just painted a thin layer to get the regidity?

cheers
Steve


I just used a very thin layer so I could manage the helmet when using the fiberglass. Actually, the helmet was sturdy enough that I could place it upside and work with it without it losing it's shape.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top