EE-3 Blaster Inner stock greeblie setup

escho34

Hunter
Hey all, it seems like we're getting a ton of good information on the EE-3 blaster recently...

I'm wondering if anyone has a good pic of the inner stock and how the D part fits in the stock on the inner side along with the stock greeblies on that side???

I know on the outside, the stock has the two long greeblies with the box one in the middle. Does the other side have the same setup?

Thanks!
 
The greebs as far as I can tell are not symetrical... in that I can only see one 3AM plug on the inside...
Don't forget these are slightly staggered and not in a straight line... ;)

stock.JPG
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top