Vest Collar closure?

Drago Lordist

New Hunter
My side is working fine on the vest I made tonight, it looks great, but I'm not sure I'm satisfied.
I used velcro on my closure and put a small peice at the edge of the shoulder pad so it stays in place. it still comes apart all the way from the neck down to the waist along the left side but I'm not sure if that shoulder will look right or if it'll be better after I attach a shoulder plate.
how do your collars close on your vests? How did the screen used one close?
Thanks for any help I can get!
 
Velcro, on the left shoulder (pic courtesy of Jango ref. cd).(y)

Armor - Collar & Back - Left.jpg
 
but see, it looks like it stops just short of the edge by maybe a half to 1 inch. it'd make sense that way cause then the shoulder pad would be attached to the front as well, but am I just seeing things? how did anyone else work it out?
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top