Quick Hello

lostdude

New Hunter
Well I already have a TX and have been working on a vader since the summer but the second I found the WOF templates and Antman's Cardboard Helmet it took me less that 24 hours to get out there and buy my supplies to start a mandalorian.

I'm a Junior at NC State University, chemistry major and pre-medical track. I look forward to this project and learning from comments. :D cheers!
 
Here are a few pictures of my other costumes/WIP

Hasbro Blaster Kit
blaster2002.jpg


TX-3729
FayettvilleTroop050.jpg


Vader Parts
vaderhead002.jpg


1st try using drywall
vaderhead001.jpg


2nd Vader Sculpt
Istset003.jpg


Comparison so far
FayettvilleTroop064.jpg
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top