Nintendo Zapper pistol

stussy

Jr Hunter
Well, here is my Nintendo Zapper sidearm...with a silencer.:D This is my first attempt at layering and using liquid mask. I must say that the mask is expensive ($25 in Canada :eek:) but it does seem to rub off good. Anyways, just thought I would show it to you all.

Stussy

IMG_3930.JPG
 
Last edited by a moderator:
Looking good!


tip for the masking fluid to keep the cost down,
Just find some average liquid latex and use that instead. Y'know the stuff they have all over the place during halloween? It's about $2 a tube, it's easier to work with , and it dries faster too.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top