The Clone Wars: Clone Trooper Helmet Templates

No problem buddy. ;) I keep thinking of going back to this one and tweaking it further. The 3D model looked Ok but the front/mouth area always looks a little off to me when I see builds????

I know you'll make yours pop though. ;)
 
Thanks buddy. I'm just about to finish up the EpII Clone lid too. ;)

Image3.jpg

Image2.jpg
 
I'm not sure if these will be accepted by the 501st. I think that most of my stuff is accurate enough although they can be quite strict so there's no guarantee. As I sad though I think they're good and with time and work during the builds these could really POP!
 
What do you need advice with? It looks like you've been building it without the visor in which I wouldn't recommend as it helps to keep the shape until you've fibreglassed it. I'd have thought that you can still add it though to get the shape??
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top