Stormrider
Well-Known Hunter
Ok the time is here to start playing with this sexy HIC I have. (IC).
Im making a face mold right now, and its about done. Im going to do them in a lightweight polyu. Shipping should be really cheap.
I dont know the cost, Probably somewhere in the $50 price range. Im not doing a run at the moment because someone has already beat me to them in the cargo hold.
I am however guaging interest in a FULL FRONTAL
I am contemplating doing it in multiple fashions. One a lightweight polyu. in three pieces that can be seamed together.
I will probably cast them as one piece, then cut them in places where the details will not get destroyed.
I also have tossed around the idea of a hard rubber HIC. That way it could be shipped cheap and easy and never worry about breaking.
The third idea is a smaller sub three piece. Face, Hands, Torso. The rest can be made pretty easily.
Finally perhaps the control boxes on the sides seperately.
Now, pricing? Thats a tough one. The silicone is going to be PRICY as this piece is 6'4'' tall. Im only going to mold the front/textured part.
I want to backfill the voids with hardening foam to make it much more robust without adding shipping weight.
Individuals could either:
A hang it on the wall/door
B build a box and make a complete
So, with that being said, your thoughts? Interest?
Im making a face mold right now, and its about done. Im going to do them in a lightweight polyu. Shipping should be really cheap.
I dont know the cost, Probably somewhere in the $50 price range. Im not doing a run at the moment because someone has already beat me to them in the cargo hold.
I am however guaging interest in a FULL FRONTAL
I am contemplating doing it in multiple fashions. One a lightweight polyu. in three pieces that can be seamed together.
I will probably cast them as one piece, then cut them in places where the details will not get destroyed.
I also have tossed around the idea of a hard rubber HIC. That way it could be shipped cheap and easy and never worry about breaking.
The third idea is a smaller sub three piece. Face, Hands, Torso. The rest can be made pretty easily.
Finally perhaps the control boxes on the sides seperately.
Now, pricing? Thats a tough one. The silicone is going to be PRICY as this piece is 6'4'' tall. Im only going to mold the front/textured part.
I want to backfill the voids with hardening foam to make it much more robust without adding shipping weight.
Individuals could either:
A hang it on the wall/door
B build a box and make a complete
So, with that being said, your thoughts? Interest?