Range finder stalk

Rc2064

Jr Hunter
Just wondering how everyone attachs the range finder to the stalk. I have a solid aluminum stalk and resin range finder. Been looking around forums and I could find a thread on it. Thanks!
 
He ya. I have the same R/F and stalk. I did mine a bit different. I Used my dremmel and dug out a shallow grove for the stalk to sit in. then I drilled two holes for the posts on the stalk ( if yours doesn't have posts, you could drill two small holes in the top and screw in small screws ) Once they where nice and aligned, I used super glue(cyanoacrylte) to fix them together. So far its never come apart.
 
That was another idea that came to mind. I'll try that later on. Right now its just 1 screw thru the bottom into the R/f. Nothing edged in stone but it holds good.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top