Prop builder in the UK

XRobots

Jr Hunter
Hi there, my name is James from the UK. Just thought I'd post a few projects that I've built in the last year by way of an introduction, and there are many older ones on my website too:

Full size R2-D2, built mostly from scratch:

http://www.xrobots.co.uk/R2-D2.htm

Full size C-3PO, which I carved out of wood to make vacuum form moulds (and I made the vac form table too):

http://www.xrobots.co.uk/C-3PO.htm

A large Jabba the hut:

http://www.xrobots.co.uk/jabba.html

...which I made for my Star Wars house party:

http://www.xrobots.co.uk/StarWarsParty/

Then I decided to build a life size Iron Man statue, which is made of cardboard and wood filler, mainly to experiment with rapid construction techniques:

http://www.xrobots.co.uk/Iron Man/

Since I didn't make the head of my Iron Man Statue, I'm now working on my own custom clay sculpt / mould / cast from Klean Klay, latex and Aqua Resin:

http://www.xrobots.co.uk/Iron Manhelmet/

That's going well, so I'm also doing the entire costume in the same way:

http://www.xrobots.co.uk/Iron Mancostume/

...the chest plate pictured is getting scrapped for a clay sculpt over a mannequin torso instead, more coming soon...
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top