Help me TD2253 Youre my Only Hope!

Katua Fett

Active Hunter
Or anyone else who might know!?

Im trying, unsuccessfully to do the zipzap RF mod.

First im worried i blew the board already. So will the green power light still turn on if the board is fried?

And second. When hooking up the buttons to the board (i knew those circle things were small....but dang there super small.) do you connect both wires from one switch to one circle? or to two circles.......(diagram used for refrence)

Oh and nobody said the headlights work:lol:

1.jpg
 
You want to have two wires from one switch going to the two halves of one circle, like in the first diagram. When you press the switch or the original control it joins the two halves together to complete the circuit.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top