Looking for Knee dart and gaunlets darts blueprints.

Lee27

Active Hunter
Guys,

Can anyone let me know where i can find the accurate dimensions for both the ROTJ knee darts and gaunlet darts?

Also,is there anything else that needs machining as im going to ask the toolmaker at work to make them all for me.

Im assuming i need 4 knee darts and four gauntlet darts.

Thanks

Lee
 
Cheers mojo.

I printed them out last week(knee darts) but the printput came out a bit wrong,and the page was slightly cropped.

Could you let me know the exact dimensions of the knee darts.
Also,i couldnt find the gauntlet dart blueprints?

Cheers

Lee
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top