Starting my WOF jet pack.

Lee27

Active Hunter
Starting my WOF rocket pack.

Guys,

Im about to start my scratch built rocket pack using WOF templates(amazing guy and amazing work!).

Id just like to ask if i need to get hold of some pipe for the large tubular sections(boosters and missile).

Is there any other advice anyone can give? should i do some extra work to make it a little stronger perhaps?

Thanks

Lee
 
If you can get the correct sized diameter pipe, then go for it! You could also get the closest size to it and form your sintra (if thats what you are using) over it, would work best for the central section.

I found super glueing it together and then using a hot glue gun in what I can best describe as a weld technique worked very well for me. I had a buld thread somewhere, will try and bump it, also check out Jango72's he made a great pack also.

What material are you using?
 
Last edited by a moderator:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top