Custom Mando beskar'gam

Flames

New Hunter
Su cuy'gar.

I'm currently planning how to make my custom Armor. I am planning to make the armor plates from vinyl flooring. The helmet I will probably have vacuformed (possibly a BradleyFett one). Colours will be black with a red trim (pix going up later).

Anyone used vinyl before. If so I would welcome any advice.

Ret'urcye mhi.
 
There was someone here a long time ago that was using linoleum flooring for armor. Hopefully he'll chime in here because I honestly can't remember...
 
I could see that being pretty nice armour... you'd have to be careful though, 'cause that stuff has a tendency to crack and split if its bent too much.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top