Michell sweep arm Disassembly??

slave1pilot

Well-Known Hunter
I got my Sweep arm in the mail today
Started to take it apart...
Ran into a snag
How do I get this rod off of the Knee Dart/Toe Spike piece?

michell 002.JPG
 
If you have access to a lathe, hold the main body in a 'soft 3 jaw chuck' and hacksaw the rod off leaving 1/16". then face off with knife tool... (at least thats what I'd do?) (y)
 
I don't know, but I would love to draft blueprints of those babies :love

Does the rod not just pull/twist out?
Would that mean that the originals were cut off then drilled out the hole?
 
I don't know, but I would love to draft blueprints of those babies :love

Does the rod not just pull/twist out?
Would that mean that the originals were cut off then drilled out the hole?

Not sure myself
I tried the twist/pull idea
No good
It has to come out
maybe some heating/cooling
It's at the Machine shop now ....8)
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top