Need help with possible casting

AncientFett

Jr Hunter
I'm working on a sonic rifle for my annimated Fett costume and I need some help. The rifle is made from 2" thk. blue board and sanded down into shape. I've used wood glue to hold the pitchfork part on but I know its a little weak. I'm thinking about inserting a dowel rod and then glueing it. Does anyone know of a good "glue" that won't eat the styrene? I even thought about bondo-ing it and sanding it but I'm not sure.

Also, once its complete, I thought about making a mold and casting it out of resin. I've never done that before so I don't know if it'll work. Anyone having any insight please post your thoughts. :confused
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top