Trimming FP v.3 armor.

KoRn3000

Active Hunter
Hi guys.
After a long postponement on my fp v.3 armor trimming, i have now dared myself to start the trimming process. In my first attempt i marked the inside of the chest armor plate with a pencil, i set the mark at 3mm (1/8" i think). I looked at the reference material that i have, but none of them shows the back of the armor. I have the feeling that my armor needs to be trimmed down some more, but i don't want to do it before i can confirm that it is supposed to be less than what i have.
Is there anyone out there that could take a pic of their inside armor piece so i have anything to compare mine to?:confused.
I'll post my attempt.

bevel.gif
 
Looks pretty good to me bruv, I have seen some that leave too much on theirs?
If you look at the ref material it does not look very thick, so your onto a winner IMO... ;)

btw... I have FP V3 armour
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top