Helmet Stands

FettDad

Active Hunter
hey guys, just wanting to inquire about the helmet stands i see alot of lids resting on in pics and stuff...do you guys by those, make 'em, any suggestions? i have a getto rig-up with a 1 x 6 in a vice out in my shop :lol:, and just would like to upgrade a little, since i am putting so much into the lid i have...thanks for the help!!
 
hey guys, just wanting to inquire about the helmet stands i see alot of lids resting on in pics and stuff...do you guys by those, make 'em, any suggestions? i have a getto rig-up with a 1 x 6 in a vice out in my shop :lol:, and just would like to upgrade a little, since i am putting so much into the lid i have...thanks for the help!!


Paper towel holders.

You can find nice, wooden ones if you look hard enough. That's what I use.
 
go to any home kitchen store and get a nice counter top paper towel holder, go to a hobby store and get a med/lrg form ball and stick it on top of the paper towel rode.... and your all set! should be no more than 20-30 bucks.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top