Jango Bucket

Naush

New Hunter
I have started to put together my own bucket, thanks to some great blueprints found here. They are perfect. However, I can tell already that the cracks where my cheek plates are coming together are going to be noticable. How can I fill these in before I paint? Obviously it needs to look like an uniform piece rather than multiple parts put together. What have you used to fill in those areas?
 
Sterling plastic garabage can bent to fit my needs. I'll try to get some pictures this evening, if I get the chance.
 
Here are some pictures of where I am with my bucket.

1st step cutting out the face with gaping back.
SANY0055.gif


Comparison to Rubies helmet.
SANY0039.gif


2nd step, making a solid back with ledge around side.
SANY0055.gif
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top