$5 "stunt" gloves for your Boba

td9993

New Hunter
I lost a glove recently and quickly needed another one. So I went to ACE Hardware, grabbed a pair of $2.50 white gloves. Used some duct tape and bought a $1.00 can of grey primer....
TA-DA!
Cheap gloves you can use when you don't want to get your other ones wrecked.

HPIM55641.gif


HPIM55671.gif



:lol:
 
You know what...that is an AMAZING idea! Good work!! I almost ripped one of my gloves at an event....I think I know what I'll go make for some "ready" spares!

Charlie
 
Because of my Mold problem I had to use this technique to make some quick gloves this morning, granted they are far from accurate and have a wells lamont logo on the back of the right hand, but they will do until I have time to make some new ones.
gloves.gif
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top