Fiber glass gauntlets...

TX-7365

Hunter
Fiber glass gaunts...

I had just picked up a nice pair of gauntlets from a TDH member a little bit ago & they just need a little bit of tweeking to fit right.

So my question is, can I heat up the fiber glass alittle to just carefully bend it just a tiney bit?
 
I have. I just used my trusty heat gun. Be careful when heating. You don't want to melt them or not get them hot enough that they don't bend.
 
Last edited by a moderator:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top