My latest clone accessory

clonesix

Active Hunter
This has be on the back burner for years, and I only now have mad a new clone belt model. This new model has the 6 front boxes molded in-place with the belt and cast as one solid unit. I like this idea much more than castig the parts separately and attaching. I left the to rear boxes and canister to be attached separately though.

The thing that has held m back for so long, was that I needed to fab two new front boxes for this model. There is a right and left slope to the front box. That neccessitated building the same thing twice, but mirrored. I admit it: I was simply too lazy to pull out the table saw.

Now that the first one is out of the mold, here is the result
beltnewwhite02.jpg

 
Last edited by a moderator:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top