Glue for sign foam question.

UMD S4L

Active Hunter
I want to try and make gauntlets using the "For Sale" signs and I was wondering what everyone would recommend for glue. I had tried using hot glue before but it looked awful. I want something that will bond well with the surface but also dry quickly. Any advice would be appreciated. :cheers
 
Maybe a two part apoxy glue??
If you design will allow it,you might be able to keep the sign together with small rivets?or some other fastner?
Sounds like a road trip to your local Home Depot or Lowes :)
 
UMD - I used Superglue for the initial connection, this allows you to connect everything very quickly and dries fast!
Then flip it over and run a beed of hot glue on the reverse side of the seam and your good to go? ;)
 
Great ideas everyone, thank you. I'm on vacation from work next week and I'm really hoping to to get my gauntlets done and the suggestions should be a huge help. Thanks again to everyone.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top