Interest in MPP Flash Copys

BobaFettSlave1

Active Hunter
Interest in MPP FlashTube Replicas

ive been looking into having copys made of my MPP flash tube
they will not have the screw on cap & thred on the end (Sorry saber guys) this is to reduce costs and the fact you dont need it. They will most likley be machined and then chromed. i havent been able to get a price quote from the machinist yet (im hoping no more than $50) but i need some interest in this project before going any further. ill need 10 to 20 interested people before going ahead. So if you are interested than please tell me
:)

Dana


PICS OF THE ORIGINAL THAT WILL BE USED TO MAKE COPYS

mpp.jpg


mpp2.jpg


mpp3.jpg


mpp4.jpg
 
Last edited by a moderator:
ok well ive hit a rather large bump in the road as the guy i was talking to has bailed on me so i need some help from the community on this project, even though it looks like this project is semi unneeded. anyone know what type of machinery and supplys ill need to make these? hopefully cuting out the machineist will greatly reduce costs.
 
Last edited by a moderator:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top