Another moldmaker/casting question

tbone9600

Active Hunter
OK... I woke up at 3 a.m., was unable to go back to sleep, and had rotocasting ideas running wild in my head. So I did what any other perfectly normal individual would do and jumped online to do some research. :lol: Anyway... I ran across this stuff, http://www.smoothonsecure.com/store/index.php?cPath=291_1_2&osCsid=3cf355dc5a021e4abbde97aa48340ba8, while looking around. I know it really has nothing to do with rotocasting, but is this what is or could be used for cold casting?

Oh yeah... I did find plans to build a rotocasting machine too.
 
Last edited by a moderator:
That was plastic with aluminum bits added to it for strength. THIS is what you are looking for. Cold casting is done by brushing the mold with the metallic powder before pouring the casting resin. :)
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top