Blaster detail parts, any interest??

Thread starter Hotshot
Start date Apr 22, 2008

Hotshot

Active Hunter

Apr 22, 2008

Hi guys,
As I'm finishing up the ROTJ STUNT Blasters, and getting moving on the ESB STUNT, I was puzzeled.

I'm doing most of the detail parts by hand, and casting them to make duplicates, and womdered; is there any need for me to cast these in a longer lasting silicone? These detail parts would be the following:

ROTJ
-accurate bomb racks
-stock plates (scratched, but realllllly nice and accturate)
-Scope with rings attached
- Muzzle tip

ESB
- Accurate V8 parts
- Molllex connectors and scope
- Stock plates (also scratchbuilt, built really nice)

Now, this is really just a yes or no question, so holler if you think its a good idea!!
Thanks!

This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.