Attaching armor (?)

That works as well. But dont put them to close to your chest lights. Ive been told that they might mess up your lights. How true that is I dont know.


That's correct, the magnets will affect the lights and cause them to go all wonky

*Edit* After discussing with the engineers at work who build things with LEDs they have informed me that I am an idiot and that magnets will not hurt the LEDs
 
Last edited by a moderator:
hey halo, how did you get the velcro on....sewing, adhesive?

Apologies on the late reply but yes, the velcro was machined sewn on. The snaps & buttons arrangement was punched thru with a leather belt hole puncher.

As for alignment for the snaps & buttons, I traced out my armor onto paper, worked out the snaps placements and marked it out on both the armor and vest. Punched the vest, and glued onto the armor.

Hope that helps.

Stay safe,

Tim.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top