rotj rattle can color

afaik, there isn't a single "correct" color... everyone has different approaches.

i use rustoleum "claret wine" (it's in the painter's touch series i think). i spray a black base coat then put some thin layers of the wine over it until it's just a bit brighter than like it, then a bit of a black mist on top for good luck.
 
i just ordered a bunch of colors from montana us (see the rattlecan thread from suspect86 i think). a couple of them are potential rotj gauntlet colors.

i'll make sure to post up how it comes out.
 
I also went with the Krylon Burg satin. Nice color after you dirty it up with a black mist. and it matches the helmet color. So being a girl, I liked that part. Its like accessorizing!

:p
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top