MMD Green Putty?

Southern hunter

Active Hunter
Progress pix using MMD Green Putty

Hi there fellow Fett-heads! :) Got a question for ya.

Has anyone ever used MMD's Green Putty as a filler for scratches, holes etc on a helmet? What kind of results did you get? Any advice or precautions on using it? I'm working on a slush-cast resin helmet, if that matters. Progress pix to follow later this week.

Thanks everyone. :cheers
 
Last edited by a moderator:
Pix

Anyone? Anyone?

Bueller? :)

Right then. I just jumped in with both feet and used the Green Putty this week. It sands easily, but has a strong smell when you first apply it. I'd give it at least an hour before you start sanding. You can apply it and smooth it out easily. It's mainly for scale models, R/C cars etc, but it seems to work well so far.

Here are some progress pix, as promised. The bondo is pink/red the green is obviously the MMD Green Putty. :) LMK what ya think guys and gals.

dome-3_19-w.jpg


Rear-3_19-w.jpg


Left-side-3_19-w.jpg
 
Last edited by a moderator:
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top