I changed my old jango fett helmet back to Boba

MAULFETT

Active Hunter
Almost a year ago i got a new BKBT Jango fett Helmet great helmet, for me is the best so my Old jango helmet (don post 1996) i decided to painted back to Boba fett but ESB version and reinforce it because this helmet is a little weak, Here some picture what i did with it.

P9110265a.jpg


PB280428a.jpg


PB300432.jpg


PC030449.jpg


PC030451.jpg


PC170509.JPG


PC170510.JPG


PC170511.JPG


PC170513.JPG
 
Wow, that's some really nice work!

How did you correct the shape? I can see some sort of support at the bottom of the helmet. Can you explain how you did this? It really made a noticeable difference in the look of the helmet. (y)
 
I draw the bottom of the helmet (the right shape ) on top of acrily panel (1/4) thin, then cut it, inside and outside the helmet drawing and put in inside the helmet with screw and epoxy.
The don post helmet 1996 is great but is a weak plastic and loose shape especially on the bottom part.
Thanks for the comments.

P.S. i did the paint too.
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top