JB Project/Rangefinder circuit

Hey Nic,
Just wanted to let you know these came in today...and all I gotta say is WOW:eek:..Fantastic work my friend...(y)

Haven't tried to fit them yet, will do later today.(y)
 
Last edited by a moderator:
is there any way to fit all the goodies in a hollow rf? board, leds, watch battery, and a gravity switch?
 
It's a simple 2 transistor flashing circuit. You can find diagrams on google.
 
If you have one of the arduino pins set to an output, the voltage from that pin could be used to power the flashing circuit. It would be easier to just use a tilt switch and a battery to turn it on and off.
I actually make a kit smaller than the one posted here, I have a sale thread in the cargo hold.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top