Painting Rubber

mandalore697

Active Hunter
Does anyone know what paint can be used on rubber?

I've got a clonetrooper belt that is cast in urethene rubber and need to know the best kind of paint to use.

Any ideas?


Thanks
 
I believe I read that Krylon Fusion was not good for foam belts... have to confirm but I clearly recall reading that somewhere on the clone forum.

If I remember correctly any Krylon non-Fusion was ok to paint the foam belts.

I just thought that maybe urethane rubber belts are not the same as foam belts.... that would explain why clonesix says Fusion is ok for these belt... as a matter of fact, you might be better of listening to clonesix ;)
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top