Can't find any tutorials

Welcome to the board! Do you have any experience with metal or fiberglass? Neither is a walk in the park, especially if you haven't work with them before. I'm not trying to avert you away from doing it yourself, but I would advise you to at least look into buying one from some of the fine artisans we have here on the board. I think it would save you some heartache and frustration, and even a little money too. If you're still set on trying it out, I would think you could use the bucket template found here http://www.thedentedhelmet.com/showthread.php?t=23195 and a thinner gauge sheet metal. Good luck!
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top