Almost completed ESB Blaster

psydaz

Hunter
Been working on this for a while...almost done.

blasterprg.jpg


Kata
 
Last edited by a moderator:
I did :D. It is a scratch built. Made from a bb gun grip (crossman if I remember), pvc, sintra, the scope I found found at Target and a drain pipe. The stock and the attachment to the gun are both made from wood.

Kata
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top