Best Way to attach resin parts to gauntlets?

Icedevil

Well-Known Hunter
So as I start looking at my Ruffkin gauntlets, I'm thinking to myself, what would be the best way to attach these resin parts to the styrene of the gauntlet? I think I'll of course start out with just plain old CA glue and hope it holds.

Do you guys think that if I were to attach some bolts to some of the bigger resin pieces that would hold securely and not rip the styrene? it is pretty thin.
 
I've built quite a few sets of these and I've always used epoxy filler and a couple of small bolts... worked very well.

DAZ
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top