Mounting RF Stalk to Resin RF

wesari

Active Hunter
Well, thanks to Sarge I've got a badass (soon to be) MH with the resin RF, and thanks to Terminal I now have a nice aluminum stalk. The problem, hopefully a small one, is that the mounting area for the stalk only leaves about 1/8 of an inch on either side of the RF and I'm afraid it's going to be a pain to Dremel and keep structural integrity on the resin... help!

Do I shorten/trim the mounting piece on the stalk? How have some of you done it?

Thanks,

Scott
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top