Opinions on CHEST DECAL WITH PIC

fettzilla

Hunter
I dont know if you can make out the picture. It is the chest decal
been printed on teslin and matt laminated to 680 micron (i,m a printer)
Its quite thin but not as flush as a transfer (sticker).It has been punched
out, The thing is it is 2" in diameter. Is this wide enough because
i,m at my threshold on the diameter of the punch?


30082007088.jpg
 
The chest emblem is raised on the real deal as well... how raised is up for debate but from what I witnessed the amount you get from a thin vinyl sticker is about right. Hope that helps. :)
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top