my sons boba project

teabo

Hunter
i'm taking any opinion will help. the helmet is rubies. the armor is cut from trash can
100_0252.jpg

100_0251.jpg

100_0249.jpg

100_0246.jpg

100_0243.jpg

100_0244.jpg

thanks
 
Last edited by a moderator:
cut the visor out and replace it. You can get visors here, about $10 on ebay, or go to a welding stor and get a visor shield and cut it.
 
ya i put a t-visor in my rubies helmet it fit fine and i put one in a DP 95 too but the rubies helmet gets soft when its really hot if you didnt kno
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top