Borden Connector - How much does it stick up?

J ROCK

Well-Known Hunter
Just installing my Mole or Borden Connector on my cheek. Just wondering how far it set out from the cheek?

J-ROCK
 
Now I'm no expert, but from the pics that I've extensively looked at over and over again while researching the helmet shape for my own scratch build, I'd say that if you had the borden connector at 1.5mm to 2mm, it should look fine.
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top