New RF Sculpt

bobamaker

Active Hunter
I recently acquired one of the 'Polaroid' cameras that contains the supposed RF window. I removed the window and compared it to my existing sculpt, it was slightly larger. With this knowledge I have resculpted my RF slightly larger (using the window as a scale marker). The new sculpt is:

  • Slightly larger than my existing version
  • Has Hollow portion for WORKING LEDs
  • Centre cast in CLEAR RESIN with green stripes
  • Edges are more rounded
  • Will fit existing stalk

i will supply the RF with the central clear resin portion separate to allow you to fit your working LEDs, once fitted you can lock in the clear portion with a blob of glue.

The pictures show the actual camera and my sculpt in it's 'almost finished' state.

DAZ

Camera.jpg


RF.jpg
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top