ROTJ Scope rail mount

Simon Fett

Active Hunter
I have bought a Tasco 4x20 scope and have almost finished my new scratchbuilt blaster but I can't seem to find a way to attach my scope to my rifle... it seem like I need some rail to mount the scope... anyone have any idea how I could make that or buy that??

Thanks!
 
I cut 4 small squares of PVC pipe(2 for each side). Then you glue 2 of the squares together, one on top of the other-
Image174.gif


Then you sand the sides to make them flush and make them just a little wider than your scope mounts. Then sand the top down flat. Then you cut a small V-groove in the side with a dremel cutoff wheel. Works like a charm-
Image175.gif
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top