New Gauntlet moulds

sl tk8456

Active Hunter
Hello!

I rarely visit this section as I normally live on the Zam topics for my girlfriend

I own an industrial vac former and make screen accurate shoulder bells hand plates, thermal dets, that kind of thing at a reasonable price for my friends in the UKG. The aim is to get us all looking cool at a low cost :)

One friend has asked if I make Boba gauntlets/armour etc. I don't at present but if I were to do this what would you guys be looking for to be improved on what's currently out there now?

*** Which parts would you like sharpend up etc ***

Bare in mind this only refers to vac formed parts

Here's a little example of what I've done so far...

DSCF1318.gif


DSCF1324.gif

new-detail.jpg

clay type stuff
DSCF1304-1.gif
 
Just want to add here that I have seen all of Johns work.

Amazing. :)

The clean sharp lines, the finish etc etc....

John, I would certainly buy some gauntlets off you. :cheers
 
ah Ian, cheers dude ;)

I've bene looking at knee parts and stuff like and I'm thinking, stuff it! I'll make a whole suit for myself. Jet back being the trickiest thing I guess
Time, time time. I need more time
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top