Finally..some progress!!!

hankey01

Hunter
I finally had a chance to work on my blaster a bit. I chiselled out the recess for the stock. The connector piece I made at work from aluminum using WOF's templates (THANKS!). I am going to paint it black.then rough up the edges with sandpaper...to "wear" it.

The stock itself a buddy made for me (THANKS!).

Here are a couple pics

HPIM1817.JPG


HPIM1816.JPG


HPIM1820.JPG
 
Last edited by a moderator:
Finished my Fett Blaster last night!! I am missing one greeblie (anyone have a spare?!?!?!). :)

I can't wait to see how my 1:1 Fett looks with it tonight!

HPIM1822.JPG


HPIM1825.JPG
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top