Instaling light kits.

CMAnavy

Active Hunter
Okay I am stumped again.

I have TF's cold cast RF top and a Hyperdine light board but I cannot for the life of me get it to fit. I PMed someone that has but no luck there. Anyone know how to make it fit? :confused
 
Okay I am stumped again.

I have TF's cold cast RF top and a Hyperdine light board but I cannot for the life of me get it to fit. I PMed someone that has but no luck there. Anyone know how to make it fit? :confused

Any chance you can show pics of the RF and LED board side by side?
 
I will have to get a diagram put together for ya CMNAVY. Havnt forgotten about ya. The real trick was bending the wires coming down from the LEDs with out them touching through the expaned window I dremeled out. There is allready one in there but it needs to be bigger. I also removed the battery and sodered two wires in there place and ran them down the stalk. I even removed the tilt swtich and sodered over it becase I found it to be to touchey.
 
Okay, I will have to keep everything in the Rf is possible.

here is a pic too!

100_3722.jpg
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top