hard hat support in a buckett?

dark1rises

New Hunter
Has anyone ever put a hard hat support system in thier jango or boba helmets??? I would love to see pics of this and maybe some instructions. I dont think epoxy would be enough to hold it in place.
What do you guys think?
 
I just scratched up the inside of my bucket where the 4 contact points are and hot glued it in place......works pretty well, I think I might have re-gled it once or twice.

J-ROCK
 
My fiberglass helmet used a hard-hat liner...I used JB Weld to install it.

On my older SgtFang mystery helmet, the resin was so light I used Industrial Velcro instead. Never had any problems either way.
 
mines fiberglass, so Ill give jb weld a try. in my sheet metal shop I found a few old hardhats and they got me thinking. Would love to see pics :)
 
I used industrial strength velcro with a hardhat liner in my fiberglass helmet.
Works great! I've had it in there for a year and a half, and it hasn't moved at all.
 
inside of my bucket. the atachment points are held in place with epoxy resin (just make sure that both surfaces are keyed).

fotka.jpg
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top