Helmet Inside

at first i thought this was the MS interior kit and once all the pictures loaded and i read your post i understood that you really made all of that

it came out terrifically.

I think it looks twice as good as it would have otherwise looked simply because i know it is handmade from found materials

nice work

-=QuinN!
 
CombatBaby ... it was actually REAL cheap to do.

Foam - $2.50
Paint - $0 had some spray cans around (primer red, orange, aluminum, flat black)
Computer chips - $0 I was throwing old 32Mb chips out
Wire - $0.10 only a few inches of hookup wire I had around

So .... < $5.00

The fan and the battery, two toggle switches and rangefinder LEDs were already in place, but if you count them that's another ($10,$5,$2,$2,$3) or another $22. That puts the entire interior, fan and lights at $25-$30 (Canadian :facepalm )
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top